•Five, 4-pound hoppers.
•Large, lighted front graphics for merchandising.
•6.4 gallon (24.2 liters) hot water tank to meet peak serving times.
•Cup clearance at 7" (17.8 cm) to accommodate common cup sizes.
•Electrical and plumbing components easily accessible through front and top.
•Variable speed motors allow control of product consistency in mixing chamber (0.75 to 6.6 grams of powder per second).
•High speed, heavy-duty whipper for complete product mixing.
•Front of machine access to tank drain for easy service.
•Key lock on the door prevents tampering.
•Bunn-o-Matic 34900 Specifications
•Crated Weight: 123.00 lbs.
•Category: Specialty Drink Dispensers
•Type: Hot Drink Machine
•Bunn Model: FMD-5
•Product #: MPN#34900.0000
•Total Watts: 1800
•Cord Attached: Yes (NEMA 5-15P)
•Dimensions: 29.3" H x 18.6" W x 21.2" D
•Brewing Capacity: Based upon incoming water temp of 50°F (10°C).
•Electrical: Models require 2-wires plus ground service rated 120V, single phase, 60 Hz 15 amp.
•Plumbing: 20-90 psi (138-621 kPa) from a 3/8" (10 mm) or larger supply line. A shut of valve should be installed in the line before the unit. Install a regulator in line when pressure is greater than 90 psi to reduce it to 50 psi. Supplied with 3/8" (10 mm male flare fitting.
If you would like to have your machine installed for a fee in the lower 48 states by a Bunn technician the rate is $86.25 for installation, calibration, service, and removal, during business hours. Off business hours it is $129.38 and holidays $172.50.Travel are the same rates mentioned above and management fee is $30.00 per service event. If you are more than 50 miles outside the location of the nearest Bunn dealership there is an additional fee of $ 86.25 to the initial installation fee.
Bunn 34900.0000 UPC 072504064956
Can not be shipped Parcel Post.